Comparison of fracture toughness properties of advanced ferritic ODS-alloys based on 0.2T C(T) specimen tests

Charles Eiselt (1) , David Hoelzer (2) , Yann de Carlan (3) , Hieronymus Hein (1) , Marta Serrano (4) , Pascal Diano (5) , Herbert Schendzielorz (1) , Andreas Seubert (1)

1 AREVA GmbH
2 ORNL - Oak Ridge National Laboratory [Oak Ridge]
3 CEA - Commissariat à l'énergie atomique et aux énergies alternatives
4 CIEMAT - Centro de Investigaciones Energéticas Medioambientales y Tecnológicas [Madrid]
5 AREVA NP - Centre Technique (FRANCE)

Based on the good experiences gained by using small specimens made of ferritic RPV materials, the Master Curve fracture toughness approach was applied to determine the fracture mechanical properties of oxide dispersion strengthened (ODS-) materials. A ferritic ODS-alloy (Fe-14Cr-1W-Ti-Y2O3) has been produced through the powder metallurgical production path via hot extrusion and hot isostatic pressing (HIP). Optimized oxide dispersion strengthened (ODS)-alloys have a promising potential to meet the foreseen requirements of components in future Gen IV power plants due to their high creep strength and swelling resistance under irradiation at elevated operational temperatures. The fracture toughness was characterized with mini 0.2T C(T) specimens in different material orientations (R-L/L-R) in the ductile-brittle and upper shelf region in the un-irradiated state, accounting especially for the ODS-material's anisotropy as one key effect of manufacturing. Despite all tests were performed in orientation required by ASTM standards E 1921 and E 1820 not all validity criteria (e.g. height of yield strength, evenness of the crack, admissible K during testing or admissible stable crack growth) were met by the ODS-material: consequently, a valid T0 value and a standard-compliant Master Curve could not be determined for the ODS-material in the transition region especially in the respective R-L orientation, also due to a comparably low fracture toughness over the whole evaluated temperature range. Promising fracture toughness properties were obtained in the crack growth direction perpendicular to the prior main deformation (extrusion) direction, where a KJQ value of 196 MPa√m at T = 22 C was measured. Within the ductile regime, only a JQ = J0.2BL technical initiation toughness value could be calculated and at T = 22 C, a comparably large JQ of 137 kJ/m2 is obtained for specimens with crack growth direction perpendicular to the extrusion direction, while in extrusion direction the toughness is again low. In addition two further ODS-materials (14YWT and PM2000) were tested and compared to the alloys above. Non-conformances of ODS relating to the material requirements in ASTM standards E1921 and E1820 were finally detected and explained.

Keywords: Fracture toughness; Mini 0.2T C(T) specimens; Master Curve; high temperature materials

Domains: Physics [physics]; Nuclear Experiment [nucl-ex]; Physics [physics]; Nuclear Theory [nucl-th]

Charles Eiselt, David Hoelzer, Yann de Carlan, Hieronymus Hein, Marta Serrano, et al.. Comparison of fracture toughness properties of advanced ferritic ODS-alloys based on 0.2T C(T) specimen tests. ASME 2016 Pressure Vessels and Piping Conference PVP2016, Jul 2016, Vancouver, Canada. pp.1-9, ⟨10.1115/PVP2016-63455⟩. ⟨cea-02442312⟩