Y. De-carlan, J. Béchade, and P. Dubuisson, CEA development of new ferritic ODS alloys for nuclear application, J. Nucl. Mater, vol.430, pp.386-388, 2009.

P. Dubuisson, Y. De-carlan, V. Garat, and M. Blat, ODS Ferritic/ martensitic alloys for Sodium Fast Reactor fuel pin cladding, J. Nucl. Mater, vol.428, p.6, 2012.

J. S. Benjamin, Dispersion strengthened superalloys by mechanical alloying, Metall. Trans. 1, p.2943, 1970.

L. Toualbi, C. Cayron, P. Olier, R. Loge, and Y. De-carlan, Relationships between mechanical behavior and microstructural evolutions in Fe 9Cr-ODS during the fabrication route of SFR cladding tubes, J. Nucl. Mater, vol.42, p.410, 2013.
URL : https://hal.archives-ouvertes.fr/hal-00828263

L. Toualbi, C. Cayron, and P. Olier, Assessment of a new fabrication route for Fe-9Cr-1W ODS cladding tubes, J. Nucl. Mater, vol.428, p.47, 2012.
URL : https://hal.archives-ouvertes.fr/hal-00679120

H. R. Sandim, R. A. Renzetti, A. F. Padilha, D. Raabe, M. Klimenkov et al., Annealing behavior of ferritic-martensitic 9%Cr-ODS-Eurofer steel, Mater. Sci. Eng. A, vol.527, p.3602, 2010.

P. Moayeart, Investigation of the martensitic transformation using dilatometry, vol.2, 2013.

A. Ayad, N. Allain-bonasso, N. Rouag, and F. Wagner, Grain Orientation Spread values in IF steels after plastic deformation and recrystallization, Mater. Sci. Forum, vol.702, 2012.

M. Praud, F. Mompiou, J. Malaplate, D. Caillard, J. Garnier et al., Study of the deformation mechanism in Fe-14% Cr ODS alloys, J. Nucl. Mater, vol.428, p.90, 2012.

M. Klimiankou, R. Lindau, and A. Möslang, Direct correlation between morphology of (Fe, Cr) 23 C 6 precipitates and impact behavior on ODS steels, J. Nucl. Mater. 367, vol.370, 2007.

S. Noh, B. Choi, C. Han, S. H. Kang, J. Jang et al., Effects of heat treatments on microstructures and mechanical properties of dual phase ODS steels for high temperature strength, Nucl. Eng. Technol, vol.45, p.821, 2013.

S. Ukai, S. Ohtsuka, T. Kaito, H. Sakasegawa, N. Chikata et al., High-temperature strength characterization of advanced 9Cr-ODS ferritic steels, Mat. Sci. Eng. A Struct, vol.115, pp.510-511, 2009.

R. Miyata, S. Ukai, X. Wu, N. Oono, S. Hayashi et al., Strength correlation with residual ferrite fraction in 9Cr-ODS ferritic steel, J. Nucl. Mater, vol.442, p.138, 2013.

M. Yamamoto, S. Ukai, S. Hayashi, T. Kaito, and S. Ohtsuka, Formation of residual ferrite in 9Cr-ODS ferritic steels, Mat. Sci. Eng. A, vol.527, p.4418, 2010.

S. Vincent and J. Ribis, Microstructural and mechanical characterization of CEA ODS steels

C. Cayron, A. Montani, D. Venet, N. Herve, and Y. De-carlan, Microstructural characterization of ODS steels after manufacturing and after creep loading, 2013.

H. Bakker, H. P. Bonzel, and C. M. Bruff, LANDOLT-BÖRNSTEIN, Group III: Crystal and solid State Physics, vol.26, p.481, 1990.

C. Y. Kung and J. J. Rayment, An examination of the validity of existing empirical formulae for the calculation of M s temperature, Met. Trans. A, vol.13, p.328, 1982.

J. L. Béchade, L. Toualbi, and S. Bosonnet, Macroscopic and microscopic determination of residual stresses in thin Oxides Dispersion Strengthened steel tubes, Mater. Sci. Forum, vol.296, pp.768-769, 2014.

L. Toualbi, Optimisation de la gamme de fabrication de tubes en aciers renforcés par dispersion nanométriques d'oxydes (ODS), 2012.